How to connect the Autel MS906 and the car with the OBD cable
Someone who never use this machine may be will not know how to connect Autel MS906 with the car , please check the picture
with steps for the connection as bellow :
(1) Connect the main cable’s 15pin female connector to the BD15 port on the top of the MaxiSys MS906 display tablet.tighten the captive screws.
(2) Connect the 16pin male connector of the main cable to the vehicle’s DTC, which is generally located under the vehicle dash.
(3) Power up the display tablet. your MasiSys MS906 is now ready for use as a diagnostic device.
